Newmarket Location Markham Location

Fix-a-Leak (8 oz)


FIX A LEAK is a blended concentrated material designed to seal virtually any material. IT can be applied for leaks in the shell and works well in the plumbing. Will seal holes 1/8'' in diameter. Will form a permanent seal. 

8 oz

237 mL


  1. If spa insulation is saturated with water, empty spa and leave empty for 1 week for foam to dry out. Refill the hot tub once the foam is dry.
  2. Remove all spa filters.
    For pools, if you have a sand filter set filter valve to by-pass the filter.
  3. With your pump running on high speed, slowly add FIX A LEAK at the skimmer or any other suction intake.
  4. After adding FIX-A-LEAK, allow your pump to run for 6-8 hours. If you have more than 1 pump, turn all pumps on periodically.
  5. Continue to re-circulate water until the leak has stopped.
  6. After the leak has stopped and given the proper time to cure (about 24 hrs), drain & clean the spa. Wipe down your spa as it is draining - do not allow the spa to dry before cleaning! For best results, leave your spa empty for 1 week after you fix the leak.
  7. Re-install filter cartridges and then remove filter cartridges after a day to rinse out any left over FIX A LEAK film. Do not allow cartridges to dry before rinsing!
    For pool sand filters: Set filter valve to filter and resume normal operation. Backwash out unused FIX A LEAK film as required.
  8. If the leak hasn't completely stopped, the treatment can be repeated.

Write Your Own Review

How do you rate this product?

Please, enter a valid value